There are many questions that arise during toilet seat hinge replacement, including: are toilet seat hinges the same? How do you replace a broken hinge? Why do toilet seat hinges keep breaking? 

And how do you know if it is time for a new hinge? Luckily, there are some easy steps you can follow to replace your broken toilet seat hinge and get it functioning again. Listed below are some of the best tips to help you replace a broken toilet seat hinge:

Can you replace a toilet seat hinge?

toilet seat hinge replacement
Source: Carmen

How can you replace the toilet seat hinge? Here are some steps you need to take. To replace the hinges, you first need to remove the old toilet seat. Then, you should unscrew the two screws holding the lid in place. 

You should work in a counterclockwise direction so you can loosen the screws. Once you loosen the screws, you should be able to lift the lid easily. Make sure to use a flathead screwdriver to remove the protective caps that cover the screws.

Remove the old bolt. Then, place the new one into the holes that were created in the old hinge. If it’s too tight, you may be able to use a nail punch to remove it. If you’re not comfortable doing this, you can also use a hammer to knock the pin out. 

A nut is located on the bottom of the bolt. Once you’ve removed the old hinge, you’ll need to remove the bolts. If you’re not comfortable working with a hammer, you can buy a toilet seat replacement kit.

Are all toilet seat hinges the same?

 Most toilet seat hinges come with two bolts and a nut attached to them. To determine whether your hinges are in good condition, you can check them at the back of the toilet. If you notice a loose seat, this could be a sign that your hinges are wearing out. 

To fix this problem, look for a rust-proof hinge, which will not need any lubrication. You can find hinges in plastic, polished brass, and brushed chrome. By following these tips, you can easily determine which hinge is faulty and replace it.

How do you fix a broken toilet seat hinge?

Your toilet seat is hanging by a thread. The other hinge is almost completely cracked. Fortunately, there are a few things you can do to fix this problem. 

First, remove the cover and seat. Then, locate the broken hinge assembly. Locate the main pin. It should be round and about 1/4-inch in diameter. Next, place the thin end of a nail punch on the center of the long hinge pin. Finally, use a small hammer to push the stem out of the hinge assembly.

Remove the toilet seat. The hinges are held in place by bolts or nuts. Turn the bolts or nuts counter-clockwise to remove them. Make sure the hinge assembly is snug. Once the hinge assembly is in place, replace the protective caps on the bolts. You should now be able to lift the seat from the toilet. 

Repeat these steps until the hinges are working properly. If this process did not work, you can take another look at your toilet seat to see if you can do it yourself.

Why does my toilet seat hinge keep breaking?

It’s very possible that your toilet seat hinge is to blame for it’s deteriorating condition. If this is the case, there are a few things you can try to fix the problem. 

First, check the hinge bolts. These can be quite rusty due to their metal construction, and you should avoid using bleach-based household detergents on them. 

Also, don’t slam your toilet seat when it’s down because this can tear off the plastic bumpers that are under the seat.

If they’re not, then you’ll need to tighten them manually. To do this, simply unscrew the bolts and tighten them by hand. Make sure you’re not over-tightening them, as this can cause the bolts to strip and break. 

Once you’ve tightened the bolts, you can now replace your seat and cover. Fortunately, you don’t have to spend a lot of money on a new hinge for your toilet!

Leave a comment

Your email address will not be published. Required fields are marked *